If the enclosure does not have any intelligence built in, basically a power supply for the drives,it isprobably going toneed some wiring doneto accomplish this, but it will not be that difficult to do. Get one of these Opens a new window, run it in mode E with the start input of the timertied to the input common. Wire its power input to the main powercoming into the enclosure,wire the NO contact of the output relay to one side of the power switch and the common of the relay output to the other side of the power switch, and set it for about .5 seconds. Whenever power is lost, when it comes back on the timer will close the relay once for .5 seconds simulating the pushing of the front panel power button. The drawback of this method is that it will always power up the enclosure whenever power is applied, but this can be remedied by...
↧